Resistance of Concrete to Rapid Freezing and Thawing

This test method covers the determination of the resistance of concrete specimens to rapidly repeated cycles of freezing and thawing in the laboratory by two different procedures: Procedure A, Rapid Freezing and Thawing in Water, and Procedure B, Rapid Freezing in Air and Thawing in Water. Both procedures are intended for use in determining the effects of variations in the properties of concrete on the resistance of the concrete to the freezing-and-thawing cycles specified in the particular procedure. Neither procedure is intended to provide a quantitative measure of the length of service that may be expected from a specific type of concrete. The values stated in either inch-pound units or SI units shall be regarded separately as standard. The SI units are shown in brackets. The values stated may not be exact equivalents; therefore, each system must be used independently of the other. Combining values from the two units may result in nonconformance.
WJE laboratories are accredited by AASHTO (R18) and ANAB (ISO/IEC 17025) to perform testing standard ASTM C666 for Resistance of Concrete to Rapid Freezing and Thawing. Contact us to learn more.
Concrete - Concrete Specimens - Freeze-Thaw Resistance - Freezing - Freezing and Thawing - Frost Resistance - Thawing
91.100.30 (Concrete and concrete products)
30111500 (Concrete and mortars)
ASTM C666 / C666M-15, Standard Test Method for Resistance of Concrete to Rapid Freezing and Thawing, ASTM International, West Conshohocken, PA, 2015,